23
Listening To The Radio
1.) Press the STANDBY button to turn
the system ‘On’.
The display shows “HELLO”.
2.) Press the TUNER/BAND button to select
the Tuner function.
An AM or FM frequency will appear on
the display.
Press the TUNER/BAND button again to
switch between the AM and FM bands if
necessary.
3.) Tune to the desired station as follows:
• Manual Tuning
Repeatedly press the SKIP – ( ) / SKIP + ( ) or TUNING / TUNING
buttons until the display shows the exact frequency of the desired station. Use
the Manual Tuning method to tune to weak or distant stations that are not
strong enough to be recognized by the Automatic Tuning system.
• Automatic Tuning
Depress and hold the SKIP – ( ) / SKIP + ( ) or TUNING / TUNING
buttons until the display begins to move, then release the buttons. The Tuner
will search up or down the band for the next strong signal and stop on that
station. Repeat this procedure until the tuner stops on your desired station.
4.) If you tuned to an FM Stereo station the STEREO indicator will appear in the
display. If the FM Stereo reception is noisy or weak, press the MONO/ST button
to select the FM Mono mode.
5.) Adjust the VOLUME, EQ, and X-BASS controls to the desired settings.
6.) When you are finished listening press the
STANDBY button to return the system
to the Standby (Off) mode.
The display changes from radio
frequency to correct time.
MS3110_112106.p65 22/11/2006, 11:4823
