21
Setting The Clock
When the system is connected to an AC
outlet the time display will show a flashing
“12:00 AM” and the “CLOCK” indicator
appears.
This is your indication that the time is incorrect and needs to be set.
Note: Although it is not necessary to set the clock in order to listen to the radio
or CD player, the clock must be set correctly if you intend to use the timer to
turn the system ‘On’ and ‘Off’ automatically.
Set the clock as follows:
1.) Press the PROGRAM button on front
panel or MEMORY button on remote
control once. The ‘Hour’ digits begin
flashing.
2.) Repeatedly press the SKIP – ( ) / SKIP + ( ) buttons on front panel or
TUNING / TUNING buttons on remote control to adjust the display to the
correct hour, AM or PM.
3.) Press the PROGRAM or MEMORY
button again to set the hour.
The ‘Minute’ digits begin to flash.
4.) Repeatedly press the SKIP – ( ) / SKIP + ( ) buttons on front panel or
TUNING / TUNING buttons on remote control to adjust the display to the
correct minute.
5.) Press the PROGRAM or MEMORY
button again to set the minutes. Only the
colon “ : ” continues flashing.
The clock begins to run.
MS3110_112106.p65 22/11/2006, 11:4821
