Filter
Top Products
Installation Guide & User Manual TELETALKER
™
Model TEL 040
8
For Wall Plate Installations
If you prefer, the TELETALKER can also be mounted on a stud-
ded wall phone plate. If you don’t have a phone plate installed,
talk to your phone company or local phone products store.
Step 1: Clip the plastic wall mounting bracket (included) into
bottom of the TELETALKER base unit. (see fig. 7)
Make sure the tabs snap in securely. This will make the
base unit level with the wall.
Step 2: Reverse the handset hanger found in the handset cradle
to prevent the handset from falling.
Step 3: Plug the short line cord into the jack on the top of the
telephone and thread the line through the channel to the
cavity on the back of the base unit.
Step 4: Hold the telephone next to the wall-phone jack and plug
the line cord into the jack, leaving any slack in the base
unit cavity. Then push the phone against the mounting
studs so the studs are hooked into the upper and lower
keyhole slots of the phone. Slide the phone down until it
snaps into place. (see fig. 7)
Step 5: Check for a dial tone. If you can’t hear a dial tone, see
In Case Of Difficulty, page 12.
Note: To remove a wall-mounted telephone, slide the phone up
and pull it slightly away from the wall. Disconnect the
line cord by squeezing the clip on the modular plug and
pulling it from the jack.
Wall Mount
Bracket
Short Wall Cord
Studded Wall
Phone Plate
fig. 7: Wall Installation