Filter
Top Products
7
TELETALKER
™
Model TEL 040 Installation Guide & User Manual
Step 5: Plug the Power Pack cord into the Power Jack located at
the top end of the telephone. Plug the Power Pack into
an unswitched AC outlet within 6 feet of the telephone.
(see fig. 5)
Step 6: Perform either Table/Desk installation or Wall installa-
tion as outlined on the following pages.
For Table/Desk Installations
Step 1: Plug the long line cord into the jack on the back of the
telephone base. (see fig. 6)
Step 2: Plug the other end of the line cord into a modular base-
board jack. Make sure both ends snap into place firmly.
(see fig. 6)
Step 3: Lift the handset and check for dial tone. If you don’t
hear a dial tone, see In Case Of Difficulty, page 12.
Note: To disconnect, squeeze the clip on the plug and pull it
out from the jack. Remove the Power Pack plug from
telephone.
fig. 5: Power Connection
fig. 6: Line Cord Connection