Filter
Top Products
Installation Guide & User Manual PhoneMax
®
Model TEL 030
Williams Sound
®
Helping People Hear
8
Step 3: Plug the short line cord into the jack on the top of
the telephone and thread the line through the chan-
nel to the cavity on the back of the base unit.
Step 4: Hold the telephone next to the wall-phone jack and
plug the line cord into the jack,leaving any slack in
the base unit cavity. Then push the phone against the
mounting studs so the studs are hooked into the
upper and lower keyhole slots of the phone. Slide
the phone down until it snaps into place. (see Fig. 7)
Step 5: Check for a dial tone. If you can’t hear a dial tone,
see In Case Of Difficulty, page 12.
Note: To remove a wall-mounted telephone, slide the phone
up and pull it slightly away from the wall.
Disconnect the line cord by squeezing the clip on the
modular plug and pulling it from the jack.
Wall Mount
Bracket
Short Wall Cord
Studded Wall
Phone Plate
Fig.7: Wall Installation
Handset Hanger
Lift up, rotate 180º, and release
Fig.6: Handset Hanger Adjustment