Filter
Top Products
BASIC OPERATIONS
See page 5 for location of button controls.
Standby Mode
The headset is automatically in standby mode when you remove it from the base;
therefore, a single press of the multifunction button will obtain a dial tone, answer
an incoming call, or end a call. After removing the headset from the base, a yellow
flashing light on the headset indicates that Standby Mode is active. If the yellow light
is not flashing, turn the headset on (instructions below).
Since standby time is extensive and the headset continues to charge any time it is
stored in the base, it is usually not necessary to turn off the headset to conserve
battery power. However, if you wish to turn the headset off and on, follow these
steps.
Turning the Headset Off and On
• Off (Standby Mode not active) – Press and hold the multifunction button on the headset
for about 3 seconds until you hear 3 beeps that descend in tone. The yellow light on
the headset will stop flashing. The headset is now off and you are no longer in Standby
Mode.
• On (Standby Mode active) – Press and hold the multifunction button on the headset for
about 3 seconds until you hear 3 beeps that ascend in tone. The yellow light on the
headset will flash every few seconds. The headset is now on and you are in Standby
Mode.
Make A Call / End A Call
You will need your phone to dial the phone number, however, you may end the call
remotely.
Make A Call
Before you begin, make sure the headset is in Standby Mode.
13
Blue Parrott B100 Wireless Headset
Blue Parrott B100 Wireless Headset
14
1. Put the headset on and position the microphone properly.
2. For a more comfortable dial tone volume, press the volume decrease button three
times before obtaining a dial tone.
3. Quickly press and release the multifunction button on the headset for 1 second.
Afterwards, you will hear a single beep. Following a brief pause (as long as 4
seconds), you will hear the second beep and then a dial tone.
4. a. Corded phones: Remove the handset from the cradle and dial as usual. After the
phone begins to ring, you may place the handset back in the cradle (the call will
not be disconnected).
b. Cordless phones: Press the talk/start button and dial as usual. When the phone
begins to ring, you may turn the handset off (the call will not be disconnected).
Note:Lifting or hanging up the handset while a call is in progress on the headset will not disconnect the call.
End the Call
Quickly press and release the multifunction button on the headset for 1 second.
Afterwards, you will hear a single beep. The call will be disconnected and the headset
will revert to Standby Mode.
Answer A Call / End A Call
The Blue Parrott B100 can answer and end calls remotely.
Answer A Call
Before answering, make sure the headset is in Standby Mode.
1. Put the headset on and position the microphone properly.
2. Within approximately 1 second, the base will detect the incoming call and the green
light on the base will flicker rapidly. You will hear a series of melodic tones in the
headset indicating an incoming call.
3. Press the multifunction button on the headset, hold for 1 second, then release.
Then you will hear a single beep. After 2-5 seconds, you will be connected to the
call.