Filter
Top Products
Connecting power to Base Unit
Plug the power adapter into an electrical outlet, and the connector into the connector
jack at the bottom of the base unit.
Setup
Getting Started
Installation of Battery
1. Remove battery compartment cover by
pressing on the indentation and sliding
downward.
2. Align the two holes in the plug with the
socket pins, then snap the plug into place.
Place the battery in the compartment with
the wires in the upper right corner.
3. Replace the battery cover by sliding it
upwards.
4. If the new battery is not already charged,
place the handset in its base unit and
allow it to charge for 10-12 hours.After that,
be sure to place the handset in its base
when not in use to insure maximum daily
performance. After the initial charge,a
maintenance charge of 8 hours should be
sufficient.
5. Average talk time on a fully charged battery
is about nine hours, standby time is
aproximately four days.
CAUTION: Use only the VTech power supply provided with your tele-
phone.
6