Filter
Top Products
PHONE LED
The
PHONE
LED lights when
the phone line is being used by
the handset.
It flashes during the
programming mode.
It flashes quickly when the line
is on hold.
BATT LOW LED
The
BATT LOW
LED will flash
quickly when the handset
battery is getting low and needs
to be recharged.
It flashes slowly when the
handset is out of the talking
range or the base station is not
powered up.
The
BATT LOW
LED glows
steadily when
MUTE
is
activated.
ONIOFF KEY
Press the
ONIOFF
key to make
a call or end a call.
FLASH KEY
Press
FLASH
to switch
between calls when Call Waiting
signal is heard.
When in
OFF
mode, pressing
FLASH
and a number key
(1,2,3,4)
selects the ringer type.
MEM KEY
Used to store telephone
numbers in memory and
perform speed number dialing.
RDUP
KEY
When you hear the dial tone,
pressing the RDUP key will dial
the last number that was called
on your phone.
It can also be used for a brief
PAUSE
when programming
speed numbers.
HOLD KEY
When using your phone, press
HOLD
to put a call on hold.
To return to the call
,
press
PHONE
or
HOLD.
EMGCY KEY (EMERGENCY CALL)
One-touch speed dial number
which can be programmed for
an emergency
#
or any other
frequently dialed number.
MUTE KEY
When using your phone, press
MUTE
to temporarily turn
off
the microphone.
To reactivate the microphone
press
MUTE
again.
UP KEY
Used to increase the earpiece
volume during a call.
Used to increase the ringer
volume during
OFF
mode.
DOWN KEY
Used to decrease the earpiece
volume during a call.
.-
Used to decrease the ringer
volume during
OFF
mode.
*/TONE KEY
In
PULSE
dialing mode, it is
used to switch to Temporary
Tone dialing mode.
Base Unit Diagram
1
IN
USE
LED
CHARGE LED
CHARGE LED
The
CHARGE
LED illuminates
steadily when the handset is in
the base cradle to indicate that
the handset battery is being
charged.
IN USE LED
Immediately after placing the
handset in the base cradle, the
IN
USE
LED flashes one
time to indicate that
initialization(assigning
a new
security code and channel) is
completed.
The
IN USE
LED flashes slowly
when the handset is being used
or an incoming call is ringing.
The
IN USE
LED flashes quickly
when the call is on hold.
POWER LED
Lights when the base unit is
powered on.
DP
I
TT (TONEIPULSE) SWITCH
Sets the phone to TT(T0NE) or
DP
(PULSE) dialing.