VTech VT 1981 Cordless Telephone User Manual


 
IC (Industry Canada)
This telephone is registered
for use in Canada.
Notice:The REN assigned to
this device denotes the
number of devices you may
connect to the telephone
loop which is used by the
device to prevent
overloading. The
termination on a loop may
consist of any combination
of devices subjected only to
the requirement that the
sum of the REN does not
exceed five (5.0).
Notice:The lndustry Canada
label identifies certified
equipment. This
certification means that the
equipment meets certain
telecommunications
network protective,
operational and safety
requirement. The
Department does not
guarantee the equipment
will operate to the user's
satisfaction.
This device complies with
RSS-210 of lndustry
Canada. Operation is subject
to the following two
conditions:(l) this device may
not cause interference, and
(2) this device must accept
any interference, including
interference that may cause
FREQUENCY
undesired operation of the
CONTROL
device.
Crystal Controlled
PLL
Synthesizer
TRANSMIT
FREQUENCY
902 MHz to 928 MHz
(All twenty channels within this
range)
RECEIVE
FREQUENCY
902 MHz to 928 MHz
(All twenty channels within this
range)
NOMINAL EFFECTIVE
RANGE
SIZE
Handset
:
18.5cm x 6.3cm x 3.6cm
(L x
W
x T) maximum
(antenna excluded)
Base
:
20.5cm
x
18.5cm
x
5.5cm
(L x
W
x T) maximum
(antenna excluded)
ANTENNA LENGTH
Handset: 6 cm
Base
:
12
cm
WEIGHT
Handset: 250 grams
Base
:
520 grams
Batteries: 50 grams
Maximum power allowed by
FCC
POWER
REQUIREMENTS
and IC. Actual operating range may
vary according to environmental
Handset
:
Self-contained nickel
conditions at the time of use.
cadmium rechargeable battery
supply,
3.6V nominal, 6OOmAh
capacity.
Power Adapter :DC 9V 8500mA
SPECIFICATIONS ARE TYPICAL AND MAY CHANGE WITHOUT NOTICE