Filter
Top Products
11
GETTING STARTED
SETTING UP AC POWER
ADAPTER
Plug the AC power adaptor into an
electrical outlet and the DC connector
to the back of the Base Unit.
CAUTION: USE CLASS 2, 9V
DC POWER SUPPLY ONLY.
SETTING RINGER
The Handset ringer is programmed
ON as the factory default setting. To
change ringer settings, see RINGER
TONE / VOLUME.
The Base Unit ringer is controlled
independently, by a switch located on
the front, right hand side (antenna
side) of the Base.
The Base ringer have 3 settings,
High, Low and Off.
TONE/PULSE SELECTION
Your Sprint cordless phone is
preset for Tone dialing. If you have
rotary (pulse) service, program the
Handset accordingly. See SET TONE/
PULSE for details.
CHARGE THE HANDSET BATTERY
PACK BEFORE USE.
The battery pack recharges
automatically whenever the Handset
is in the Base Unit. The battery pack
must be charged for 16 hours before
using your phone for the first time.
CONNECT THE TELEPHONE
LINE CORD
Plug one end of the telephone line
cord into the jack on the back of the
Base Unit, plug the other end of this
cord into the wall jack.
CHECK FOR A DIAL TONE
After the battery is charged, rotate
the Base Unit antenna to upright posi-
tion. Now press PHONE on the Hand-
set. PHONE ON will appear on the
LCD, and you will hear a dial tone. If
not, see IN CASE OF DIFFICULTY.
Fill in the telephone number card on
the Base Unit.
CAUTION:
1.Never install telephone wiring dur-
ing a lightning storm.
2.Never install telephone jacks in
wet locations unless the jack is
specifically designed for wet loca-
tions.
3.Never touch uninsulated tel-
ephone wires or terminals unless
the telephone line has been dis-
connected at the network inter-
face.
4.Use caution when installing or
modifying telephone lines.