Filter
Top Products
32
of this product. The telephone service
provider is required to notify you if such
changes are planned.
If this product is equipped with a corded
or cordless handset, it is hearing aid
compatible.
If this product has memory dialing
locations, you may choose to store
emergency telephone numbers (e.g.,
police, fire, medical) in these locations.
If you do store or test emergency
numbers, please:
Remain on the line and briefly explain
the reason for the call before hanging up.
Perform such activities in off-peak hours,
such as early morning or late evening.
Industry Canada
This device complies with Industry
Canada license-exempt RSS
standard(s).
Operation is subject to the following
two conditions: (1) this device may not
cause harmful interference, and (2) this
device must accept any interference
received, including interference that
may cause undesired operation.
Privacy of communications may not be
ensured when using this phone.
The term ‘’IC:‘’ before the certification/
registration number only signifies
that the Industry Canada technical
specifications were met.
The Ringer Equivalence Number (REN)
for this terminal equipment is 0.1. The
REN is an indication of the maximum
number of devices allowed to be connected
to a telephone interface. The termination
on an interface may consist of any
combination of devices subject only to
the requirement that the sum of the RENs
of all the devices does not exceed five.
This product meets the applicable
Industry Canada technical
specifications.
California Energy
Commission battery
charging testing
instructions
This telephone meets the California Energy
Commission (CEC) regulations for energy
consumption. It is not necessary to activate
the energy conserving mode during normal
usage, unless you want to charge the battery
only and disable all telephone functions.
To activate the CEC battery charging
testing mode:
1. Unplug the telephone base power
adapter from the power outlet. Make sure
all handsets are plugged with charged
batteries before proceeding.
2. While you press and hold
/FIND HANDSET, plug the telephone base
power adapter back to the power outlet.
3. After about 20 seconds, when the
IN USE light starts flashing, release
/FIND HANDSET and then press it again
within 2 seconds.
The process takes up to one minute to
complete. When the phone successfully
enters the CEC battery charging testing
mode, the IN USE light turns off and all
handsets display To register HS... and
...see manual alternately.
When the phone fails to enter this mode,
repeat Step 1 through Step 3 above. The
telephone base will be powered up as
normal if you fail to press /FIND HANDSET
within 2 seconds in Step 3.
To deactivate the CEC battery charging
testing mode:
1. Unplug the telephone base power adapter
from the power outlet, and then plug
it back in. Then the telephone base is
powered up as normal.
2. Place the handset in the telephone base
to register it back. The handset displays
Registering....
NOTE
The handset shows Registered and you
hear a beep when the registration process
completes. The registration process takes
about 90 seconds to complete.
•