Filter
Top Products
6
Call waiting
When you subscribe to call waiting service from your telephone service
provider, you hear an alert tone if there is an incoming call while you are on
another call.
Press /FLASH to put the current call on hold and take the new call.
Press /FLASH at any time to switch back and forth between calls.
Temporary ringer silencing
When the telephone is ringing, you can temporarily silence the ringer of the
handset without disconnecting the call. The next call rings normally at the
preset volume.
To silence the handset ringer, press OFF/CANCEL or MUTE/DELETE on
the handset. RINGER MUTED and display.
Temporary tone dialing
If you have pulse (rotary) service only, you can switch from pulse to tone
dialing temporarily during a call.
During a call, press TONE .
Use the dialing keys to enter the relevant number. The telephone sends
touch-tone signals.
The telephone automatically returns to pulse dialing mode after you end
the call.
Find handset
Use this feature to find all system handsets.
To start paging:
Press /FIND HANDSET on the telephone base once and then release.
All idle handsets ring and their screens show ** PAGING **.
To end paging:
Press /FIND HANDSET again on the telephone base once and
then release.
Press /FLASH, or any dialing key (0-9, TONE or #) on the handset.
Place the handset in the telephone base or charger.
Redial list
Each handset stores the last 10 telephone numbers dialed.
To review and dial a number from the redial list:
Press REDIAL/PAUSE when the handset is not in use.
Press , , oror REDIAL/PAUSE repeatedly until the desired entry displays.
Press /FLASH to dial.
To delete a redial entry:
When the desired redial entry displays, press MUTE/DELETE.
Join a call in progress
You can use up to two system handsets at a time on an outside call. You
can buy additional expansion handsets (CS6409) for this telephone base.
You can register up to five handsets to the telephone base.
When a handset is on a call, press /FLASH or on another handset to
join the call.
Press OFF/CANCEL to exit the call. The call continues until all handsets
hang up.
Intercom
Use the intercom features for conversations between two handsets.
Press INT on your handset when it is not in use. When you have
three or more handsets, use the dialing keys to enter a destination
handset number.
To answer the intercom call, press /FLASH, , INT or any dialing key
(0-9, TONE , #) on the destination handset.
To end an intercom call, press OFF/CANCEL or place the handset back in
the telephone base or charger.
•
•
•
1.
2.
3.
•
•
•
•
1.
2.
3.
•
•
1.
2.
3.
Do not press and hold /FIND HANDSET for more than four seconds. It may
lead to handset deregistration. If 1.PRESS FIND HS ON BASE 4 SEC and
2.THEN PRESS # ON HANDSET display alternately on the handset, refer
to Troubleshooting to register the handset to the telephone base.