Filter
Top Products
2
Telephone base and charger installation
Install the telephone base and charger as shown below.
Telephone
line cord
Telephone base
Charger
Telephone base
power adapter
If you have DSL
high speed Internet
service, a DSL filter
(not included) is
required.
Electrical
outlet not
controlled by a
wall switch
Electrical
outlet not
controlled by
a wall switch
Telephone
wall jack
Charger adapter
Use only the power adapter and battery supplied with this product.
To order a replacement, visit our website at www.vtechphones.com or
call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call
1 (800) 267-7377.
The power adapter is intended to be correctly oriented in a vertical or
floor mount position. The prongs are not designed to hold the plug in
place if it is plugged into a ceiling, under-the-table or cabinet outlet.
•
•
Battery installation
Install the battery as shown below.
3
Slide the battery compartment
cover towards the center of the
handset until it clicks into place.
4
Place the handset in the
telephone base or charger
to charge.
CHARGE light
remains on when
charging.
1
Plug the battery connector
securely into the socket.
2
Place the battery with the label
THIS SIDE UP facing up and
the wires inside the battery
compartment.
If the handset will not be used for a long time, disconnect and remove the
battery to prevent possible leakage.
Battery charging
Once you have installed the battery, the screen indicates the battery status (see
the table on the next page).
For best performance, keep the handset in the telephone base or charger
when not in use.
The battery is fully charged after 10 hours of continuous charging.
If you place the handset in the telephone base or the charger without
plugging in the battery, the screen displays NO BATTERY.
•
•
•