VTech CS6114-2 Telephone User Manual


 
23
Call log empty
There are no call log entries.
Directory empty
There are no directory entries.
Directory full
The directory is full.
Ended X:XX:XX
You have just ended a call.
Incoming call
There is an incoming call.
Line in use
A system handset is in use, or another telephone on
the same line is in use.
Low battery
The battery needs to be recharged.
Microphone on
MUTE is turned off and the person on the other end can
hear you.
Muted
You have turned off the handset microphone. The other
party cannot hear you but you can hear the other party.
New voicemail
There are new voicemail message(s) from the
telephone service provider.
No battery
No battery is installed. Follow the directions for
battery installation on page 3 to install the battery
before charging.
No line
There is no telephone line connected.
No signal
Communication between the handset and telephone
base is lost during a call.
Not available
One handset is already reviewing the call log and the
other handset tries to review it.
Not registered
The handset may be deregistered from the telephone
base. Follow the instructions on page 26 to register the
handset to the telephone base.
Out of range or
no pwr at base
The handset cannot communicate with the telephone
base. Check the telephone base power connection or
move the handset closer to the telephone base.
Phone X:XX:XX
The handset is on a call.
Place in charger
The battery is very low. Place the handset in the
telephone base or charger for recharging.
Ringer muted
The handset ringer is muted temporarily during an
incoming call.
Ringer off
The handset ringer is turned off.
Saved
Your selection has been saved.
XX missed calls
There are calls that have not been reviewed in the
call log.
** Paging **
The system handsets are being paged.
Display screen messages
Appendix