WALL
M
OUNTING
The Wall Mount adaptor is designed
to fit on standard Wall Mount plates.
Choose a spot near an
electrical outlet and a
telephone
jack.Your phone
requires a modular telephone jack
and a standard electrical
outlet(l20v
AC).
The power cord
is six feet long; make sure there
is an electrical outlet within reach
of the base. The outlet should not
be controlled by a wall switch. If
the switch is ever turned off, the
phone will not operate.
I
I
WHEN
I
WALL
MOUNTING
ANDTELEPHONE
JACK
Position the wall mount adaptor
on the base. Line up the tabs on
the wall mount adaptor with the
holes on the bottom of the base.
Snap the wall mount adaptor
firmly in place.
Mount the base on the wall.
Position the base so the mounting
studs will fit into the holes on the
bottom of the
base.Position the
power cord to extend down the
wall the phone is to be mounted
on. Slide the base down on the
mounting studs until it locks into
place.
INSERT WALL MOUNT
INTO THE BASE UNIT
Connect the telephone cord.
The telephone line cord has a
snap-in plug at each end. Insert
one of the plugs into the jack on
the bottom of the base. Insert
the other end of the plug into the
wall jack.
Plug the AC adaptor into an
electrical outlet, and the DC
connector on the back of the
Base Unit.
JACK
IMPORTANT:
When wall mouting your
917ADX,
you must reverse the handset
hook, located in the charging
cradle.
Otherwise your handset may fall
I
from the Base Unit when cradled.
