Filter
Top Products
7
Setup
1. Plug the AC power adapter into an electrical outlet, and the DC connector
into the back of the base unit.
Connecting to phone line
Plug one end of the telephone line cord into the jack on the back of the base unit. Plug
the other end of this cord into the wall jack.
Checking for dial tone
After the battery is charged press ON on the Handset. The Phone icon will
appear on the handset display, and you will hear dial tone. If not, see In Case of Difficulty.
Tone/Pulse selection
The TONE/PULSE switch is located on the bottom of the Base Unit, next to the telephone
jack. It is factory set to TONE. If you have rotary (Pulse) service, set the switch to
PULSE.
CAUTION: Use only the 7 volt power adaptor provided with your GIGAPHONE.
Getting Started
To AC outlet
To telephone
jack
To telephone
socket outlet
AC adapter
IMPORTANT:
FOR MAXIMUM PERFORMANCE OF
YOUR CORDLESS TELEPHONE SYSTEM:
1. Choose a central location for your Base Unit.
2. Install your Base Unit and Extension Handsets
away from electronic equipment, such as personal
computers, television sets and microwave ovens.
3. In locations where there are multiple cordless
telephones, separate base units as much as possible.
4. Install your telephone equipment away from
heat sources and sunlight.
5. Avoid excessive moisture, dust or extreme cold.