Filter
Top Products
24
BASIC OPERATION
to increase or decrease the volume.
Holding either key down will
continuously change the volume setting.
The earpiece volume level indicator on
the display will change accordingly.
There are four volume levels.
FLASH
You can use your VTech VT 1930c
cordless phone with services such as
Call Waiting. Simply press the PHONE
key to FLASH the line.
REDIAL
To REDIAL the last number you dialed,
press the PHONE key, then press
REDIAL . The phone will automatically
dial the number. The number will be
shown on the display.
Clearing The Display
The display can be cleared by pressing
and holding the CLR/DEL key down
until the display clears.
MUTE
¥ Press MUTE during an active call
to disable the microphone.
¥ Press MUTE again to return to
normal operation.
Ringer MUTE
¥ Press MUTE during incoming
ringing to disable the ringer for the
duration of the call.
HOLD
¥ Press HOLD on the Handset or
Base Unit to place an active call on
hold.
¥ To return to the call on the Handset,
press either PHONE or HOLD .
¥ To return to the call on the
Speakerphone, press either HOLD
or SPKP .
Making Calls
From the Handset:
Press the PHONE key and wait for
dial tone. Then dial the number you
want.
Or
Enter the number onto the display first,
then press the PHONE key. This
will dial the number that is displayed
on the display after 2 seconds. See
ADVANCED DIALING.
If you make a mistake when dialing,
press OFF to hang up, then press
the PHONE key to get the dial tone
again.
From the Base Unit:
¥ Press the SPKP key and wait for
dial tone. Then dial the number you
want.
Disconnecting
To end a call, either place the handset
back in the base, press OFF on the
handset, or press SPKP on the Base
Unit (for speakerphone calls).
Answering Calls
From the Handset:
Press any key other than OFF , MUTE
or the VOLUME keys to answer your
call.
From the Base:
Press the SPKP key.
VOLUME Controls-Handset
The volume controls for the handset
are located on the side of the unit.
Press the (up) or (down) keys