Call Transfer Feature
You can transfer an outside call to the original unit. For more
instructions, see the owner’s manual supplied with the original unit.
– 6 –
•If you transfer a call and it is not picked up after 5 minutes,
you hear a beep, and the call will be disconnected.
•Only one handset at a time can talk with an outside caller.
To transfer a call to the Press xfer/del during a call.
original unit When the original unit receives the
transferred call, the TXC580 handset
returns to the standby mode.
To receive a transferred call Press talk/flash or spkr to answer
from the original unit the transferred call.
To cancel the transfer Press talk/flash or spkr.
I.C. Notice
TERMINAL EQUIPMENT
NOTICE: This equipment meets the applicable Industry Canada
Terminal Equipment Technical Specifications. This is confirmed by
the registration number. The abbreviation, IC, before the
registration number signifies that registration was performed based
on a Declaration of Conformity indicating that Industry Canada
technical specifications were met. It does not imply that Industry
Canada approved the equipment.
NOTICE: The Ringer Equivalence Number (REN) for this terminal
equipment is marked on the equipment itself. The REN assigned to
each terminal equipment provides an indication of the maximum
number of terminals allowed to be connected to a telephone interface.
The termination on an interface may consist of any combination of
devices subject only to the requirement that the sum of the Ringer
Equivalence Numbers of all the devices does not exceed five.
RADIO EQUIPMENT
The term “IC:” before the radio certification number only signifies
that Industry Canada technical specifications were met.
Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired
operation of the device. “Privacy of communications may not be
ensured when using this telephone”.
UU812BH (TXC580) ENG 7/19/02 10:23 AM Page 6