Register the Handset
You need to register the TXC580 before use.
To register the additional handset, place the TXC580 handset on the
original unit’s base for at least 5 seconds. The status LED on the
original base will flash indicating that registration is occurring.
After 5 seconds, the TXC580 handset will be registered.
•In some cases you may need to attempt registration
a few times.
•You cannot register the handset when the original phone
is in use.
– 5 –
Using the TXC580 with the
Integrated Answering Device
If the original unit has a built-in answering system, you can check
your new messages, skip, repeat, or delete your messages with the
TXC580 handset. For more instructions, see the owner’s manual
supplied with the original unit.
•If you press end before the answering system answers, the
phone will return to the standby mode.
•When the answering system does not answer within 7
seconds, you will hear a beep and the phone will return to
the standby mode.
•When you receive a call, the remote operation is canceled.
To playback a message Press -.
To skip a message Press 3.
To repeat the current message Press 1 after four seconds.
To repeat the previous message Press 1 within four seconds.
To delete a message Press 4.
To stop operation Press end.
UU812BH (TXC580) ENG 7/19/02 10:23 AM Page 5