Filter
Top Products
ADDITIONAL INFORMATION
[ 51 ]
ADDITIONAL
INFORMATION
Troubleshooting
If your phone is not performing to your expectations, please try these simple steps first.
SSyymmppttoomm
The
ssttaattuuss
LED won´t light
when the handset is placed
in the base unit.
The audio sounds weak
and/or scratchy.
Can´t make or receive calls.
The handset doesn´t ring
or receive a page.
The Caller ID/CIDCW does not
display.
SSuuggggeessttiioonn
• Make sure the AC adapter is plugged into the base unit and wall outlet.
• Make sure the handset is properly seated in the base unit.
• Make sure the charging contacts on the handset and base unit are clean.
• Press during a call to help eliminate background noise.
• Make sure that the base unit antenna is in a vertical position.
• Move the handset and/or base unit to a different location away from metal
objects or appliances and try again.
• Make sure that you are not too far from the base.
• Check both ends of the base unit telephone line cord.
• Make sure the AC adapter is plugged into the base unit and wall outlet.
• Disconnect the AC adapter for a few minutes, then reconnect it.
• Reset the digital security code (See page 47).
• Make sure is pressed.
• The battery pack may be weak. Charge the battery on the base unit for
more than 15 hours.
• The handset may be too far away from the base unit.
• Place the base unit away from appliances or metal objects.
• Reset the digital security code (See page 47).
• The handset was picked up before the second ring.
• The call was placed through a switch board.
• Call your local telephone company to verify your Caller ID service
is current.
• Charge the handset.
TRU348 6/18/01 9:54 AM Page 51