Filter
Top Products
[ 13 ]
BASICS
BASICS
The tone feature only
applies when the dial
mode is set to pulse.
Tone Dialing Switch-over
Some telephone companies use equipment that require pulse
dialing (sometimes referred to as rotary dialing). If you need
to enter tone dialing digits, you can switch-over to tone
dialing during the call. An example of this could be entering
your bank account number after you have called your bank. The
digits of your bank account can be sent using DTMF tones.
Initially make your call with the pulse dialing mode. Once your
call connects, press
*
/
ttoonnee
. Enter the desired number (like in
the example above the bank account number). These digits will be sent as tone
dialing. This special number can be stored in a memory location. This is referred to
as Chain Dialing (See page 17.). Once the call ends, the tone mode is canceled and
pulse dialing mode resumes.
Traveling Out-of-Range
During a call, as you begin to move your handset too far from your base unit, noise
increases. If you pass the range limits of the base unit, your call will terminate
within 30 seconds.