Filter
Top Products
[10] INSTALLING THE PHONE
www.uniden.com
C. Connect the Base Unit and Charge the Handset
1) Connect the AC adapter to the DC IN 9V jack and to
a standard 120V AC wall outlet.
2) Place the handset in the base unit with the keypad
facing forward.
3) Make sure the charge/in use LED illuminates.
If the LED does not illuminate, check to see that the AC
adapter is plugged in and the handset makes good
contact with the base charging contacts.
• Connect the AC adapter to a continuous power
supply.
• Place the base unit close to the AC outlet to
avoid long extension cords.
4) Charge your handset at least 15-20 hours before
plugging the phone line.
5) Once the handset battery pack is fully charged,
connect the telephone line cord to the TEL
LINE jack and a telephone outlet.
If your telephone outlet isn't modular, contact
your telephone company for assistance.
Route the cord.
Route the cord.
Route the cord.
Modular
•Use only the supplied
AD-0001 AC adapter.
Do not use any other
AC adapter.
•Do not place the power
cord where it creates a
trip hazard or where it
could become chafed
and create a fire or
electrical hazard.
!
INSTALLING THE
PHONE
UP078.book Page 10 Thursday, December 14, 2006 1:58 PM