Filter
Top Products
INSTALLING THE PHONE [9]
www.uniden.com
B. Install the Rechargeable Battery Pack into the Handset
The handset is powered by a rechargeable battery pack.
The battery recharges automatically when the handset is placed
in the base unit.
1) Press down on the handset battery case cover (use the
finger indention for a better grip) and slide the cover
downward to remove.
2) Plug the battery pack connector (red & black wires) into the
jack inside the battery compartment.
(The connector notches fit into the grooves of the jack only
one way.) Match the wire colors to the polarity label in the
battery compartment, connect the battery and listen for a
click to insure connection.
3) Make sure you have a good connection by slightly pulling on
the battery wires. If the connection is secure, the battery
jack will remain in place.
4) Place the battery case cover back in the handset by sliding
it upwards until it clicks into place.
Use only the Uniden
(BT-905 or BT-1006)
rechargeable battery
pack supplied with your
cordless telephone.
!
INSTALLING THE
PHONE
UP078.book Page 9 Thursday, December 14, 2006 1:58 PM