To charge the nickel-cadmium battery:
Using the AC Adaptor/Charger
1. Plug the AC adaptor/Charger into the Charging
Jack located on top of the unit.
WARNING! Use only the supplied AC
Adaptor/Charger. Any other AC Adaptor or
external power plug having over-voltage or
reversed polarity can cause overheating or
damage to the circuitry.
2. Plug the charger into a standard AC outlet.
To fully charge the battery, leave the Adaptor/
Charger connected for between 9 and 11
hours.
Note: Switch OFF the unit while the
battery is charging.
"
3. When charging is complete, disconnect the
Adaptor/Charger from the AC outlet, and from
the radio.
Mounting the Flexible Antenna
Place the end of the antenna onto the TNC
connectoron top of the radio andturn clockwise
untiltight.
Installing the Belt Clip
Place the Belt Clip slightly above the mounting
area on the back of the radio, and press
downward and in.
6 U H-O53