Uniden UH-O53 Two-Way Radio User Manual


 
Low Battery Level Detection
Uniden Sundowner
UH-oS3 has a built-in
battery level detector circuit. It evaluates your
Battery Pack everytime you transmit to
determinewhetherthe power insidethe Battery
is still sufficient enough to support normal
Receive and Transmit communications.
When the PTT switch is pressed and the TX
LED blinks. It means the battery level is already
Iow and needs recharging. Under this condition,
the unit no longer transmits RF Power. Have
your battery charged fully or replaced by a fully
charged battery to resume normal operation.
Care and Maintenance
TheUH-OS3is designedto giveyoutrouble-free
service. There are no user-serviceable parts
inside,and exceptfor occasionallyreplacingthe
rechargeable battery, no maintenance is
required.
Warning!Unidendoesnot representthisunit
to be waterproof Do not expose the unit to
moisture. Rain, dew, or other liquids may
damagetheinternalcomponents.
Replacing the Rechargeable Battery
When it is time to install a new battery, use only
the one made for this radio. Any other type of
battery may damage your unit.
To replace the battery:
1. Remove the Belt Clip by lifting the tab and
carefully sliding upward and out.
2. Remove the battery compartment cover on
the back of the radio by pressing in and
sliding the cover down and off.
3. Remove the rechargeable nickel-cadmium
battery and replace with a new one. Be sure
the terminals on the battery match up with the
contacts in the radio.
4. Replace the battery compartment cover by
sliding it back into place until it clicks.
5. Replace the Belt Clip.
Note: Be sure to recharge the battery before
using the radio.
8
UH-O53