Filter
Top Products
7
TO OPERATE IN DUPLEX MODE
Duplex mode is only available from CH01 – CH08. Duplex
mode is activated on a per channel basis and transmitting
frequency on Duplex channels is CH31 – CH38. E.g., If the
Repeater channel for your area is CH01, then while in Duplex
mode the Transmit channel will become CH31
with the Receive channel being CH01.
SCANNING
The scan function scans all channels and stops at an active
channel. When the signal stops, the waits 2
seconds (Reply Delay) before scanning resumes.
UH041/UHO41P
To initiate scanning,
1. Assuming the unit is on CH01
when switched on.
2. Press and hold Channel or
for 3 seconds and scanning starts
and Scan icon is displayed.
3. Press or to cancel
scanning.
PTT
If Channel or is pressed while the unit is
paused on a channel, scanning is resumed.
DUP
SCAN
volume
channel/
scan
dup mon
hi/lo
dup
dup
dup
Press momentarily. The icon
appears.
Press again to deactivate the duplex
operation. will return to
normal operation.
'DUP'
Note: If is pressed when the channel is
not from CH01 - CH08, an error tone sounds.
UH041/UHO41P
UH041 Manual.prn
UH041 Manual - UT01912AZ
Monday, October 13, 2003 6:52:28 PM
Color profile: Disabled
Composite Default screen