Filter
Top Products
– 3 –
Installing Your Expansion Handset
Follow these three easy steps to get your new handset ready to use:
1
Install the battery pack.
2
Connect the charger and charge your new handset for 15 hours.
3
Register your new handset to the main base.
Step 1: Install the Battery Pack
1
Press down on the handset battery case
cover (use the finger indention for a better
grip) and slide the cover downward to
remove.
2
Place the battery pack in the battery
compartment with the connectors on the
battery and on the compartment aligned.
3
Place the battery case cover back on the
handset and slide it upwards until it clicks
into place.
• Use only the Uniden battery (BT-
0003) supplied with your phone.
Replacement batteries are also
available through the Uniden Parts
Department. (See page 2.)
•Recharge your handset on a regular
basis by returning the handset to
the charger after each phone call.
Rechargeable Ni-MH Batteries
Must Be Recycled or Disposed of Properly
UU893BH_TCX440.fm Page 3 Monday, September 5, 2005 11:49 AM