Filter
Top Products
SETUP
Installing the Batteries
1.Open the cover
2.Insert Batteries
Note: If you are installing alkaline batteries, set the
switch to REG. ALK.BATT. If installing nickel-
cadmium batteries, set the switch to Ni-Cd
BATT.
3.Replace cover and press down
until it clicks into place.
Do not mix alkaline
batteries with Ni-Cd
batteries. Be sure to
install four batteries
of the same type.
AC Adapter/Charger
Use the optional AC adapter/charger to power the
UBC61XLT from an AC outlet.
Charging Warning
Do not charge alkaline batteries in this scanner.
Doing so may cause serious damage to the prod-
uct and void the warranty. Before attempting to
recharge batteries, make sure you have installed
four rechargeable nickel-cadmium batteries and the
selector switch is set to Ni-Cd BATT.
Flexible Antenna
Attach the flexible
antenna to the BNC
connector.
Belt Clip
Do not tighten the
screws too tight. You
can damage the case
or clip.
Optional Accessories
AC Adapter / Charger
Cigarette Lighter Lead
Press in
Lift
Ni.-Cd.
BATT.
REG.
ALK.
BATT.
Inside
of top
cover
WARNING
Use only the optional AC adapter.
4
UBC61 scanner Qk 3/12/02 11:22 AM Page 4