Filter
Top Products
26
Registering a handset
Does the handset fit in the base cradle?
Yes No
Place the handset in
the base. The display
should say
Handset
Registering
.
Disconnect the base AC adapter.
Press and hold
FIND
while you reconnect the adapter.
On the handset, press and hold
POUND (#)
until the
display says
Handset Registering
(about 2 seconds).
1.
2.
3.
In about 30 seconds, the display should say
Registration Complete
. Pick
up the handset and press
TALK
. Make sure you get a dial tone.
If... Try...
you don't hear a dial tone
the display says
Registration Failed
-
-
Making sure the handset is fully
charged, then trying again.
To register a handset to a different base, see the section "Expanding
Your Phone" in the user's guide for the other base.
Handling Liquid Damage
Moisture and liquid can damage your cordless phone.
If the handset or base is exposed to moisture or liquid, but only the
exterior plastic housing is affected, wipe off the liquid & use as normal.
If moisture or liquid has entered the plastic housing (i.e. liquid can
be heard in the phone or liquid has entered the handset battery
compartment or vent openings on the base), follow the steps below:
Handset Base
Remove the battery cover and leave it off for
ventilation.
Disconnect the battery pack. Leave the battery
cover off & the battery pack disconnected for at
least 3 days.
Once the handset is completely dry, reconnect
the battery pack and the battery cover.
Recharge the battery pack for 15-20 hours
before using.
1.
2.
3.
4.
Disconnect the AC
adapter, cutting off
electrical power.
Disconnect the
telephone cord from
the base.
Let dry for at least 3
days.
1.
2.
3.
IMPORTANT: You must unplug the telephone line while recharging
the battery pack to avoid charge interruption.
CAUTION! DO NOT use a microwave oven to speed up
the drying process. This will cause permanent damage
to the handset, base and the microwave oven.