Filter
Top Products
39
Selecting the message record time
You can set your answering system to record messages up to one
or four minutes long.
One minute option:
move the
REC TIME
switch to 1.
Four minutes option:
move the
REC TIME
switch to 4.
Announce only feature:
The announce only feature plays an outgoing message, but it will
not allow the caller to leave a message. Move the
REC TIME
switch to the ANN position.
The message counter LED displays “ ” when system is on
standby.
Prerecorded outgoing message for Announce only feature is:
“Hello, no one is available to take your call.” (twice)
REC TIME
ANN/4/1
Selecting a PIN code
To play your messages from a remote location, you will need to
enter a two-digit Personal Identification Number (PIN) code
(00-99). To select a PIN, perform the following steps.
1 On the base, press and hold
until a beep sounds and the LED
displays .
2 To set the first number, press
or
repeatedly to scroll from 0 to 9.
When the desired number appears in
the display, press .
3 To set the second number, press
or to scroll
from 0 to 9. When the desired
number appears in the display, press
. Then the entered PIN code is
announced.
pin
skip/
skip
repeat
Holding or
to scroll
through numbers on the
display.
skip
repeat
ª
pin
skip
repeat
pin