Filter
Top Products
Chain Dialing
On certain occasions, after dialing a number, you may be requested by the
party or service you are calling to enter a special access code, such as when
performing a banking transaction. To do this, simply:
1. Store the access code into one of the memory numbers.
2. Dial the main number.
3. At the appropriate time, press
mem
followed by the memory location
number where the access code is saved.
Erasing a Stored Number
To erase a number previously stored in a memory location (01-20),
follow these steps:
1. Remove the Handset from the Base Unit.
2. Press
mem
twice.
3. Press the two-digit memory location
number (01-20).
Example:
for memory location 02,
you would press 0, then 2.
A confirmation tone (double beep) indicates
that the number is erased.
If you enter a invalid two-digit memory
location, a loud single beep sounds.
j
If more than 30 seconds elapse between each keystroke entry or step, an
error tone will sound and the erase procedure will be canceled.
28 EXS9005