Filter
Top Products
7
3) If you need the phone to pa use during the d ialing seque nce, press
the redial/p key to insert a two-second delay between the
numbers. You can enter multiple pauses to increase the delay.
Each pause counts as a digit.
4) Press the memory key again.
5) To store this number as one o f the ten spee d dial numbers, enter a
digit from 0 to 9. If there is already a number in that speed dial
setting, it will overwrite the previo usly stored number without
warning. You will hear a confirmation tone indicating that the
number has been stored.
NOTE: When storing numbers into memory, if the handset is idle
(i.e., no key is pressed) for more than 30 seconds, it will beep rapidly, and the phone
will return to standby mode.
Dialing a Stored Number
1) When the phone is in standby mode, pr ess the talk key, and listen for a dial tone.
2) Press the memory key a nd enter the speed dial entry (0-9) that has t he stored number you
want to dial. (If you enter a digit that does not contain a stored number, the handset will
beep rapidly, and the phone will not dial.)
Chain Dialing
The speed dial memory is not limited to phone numbers. You can store any number (up to 20
digits) that you need to enter once your call connects. This is referred to as Chain Dialing.
For example, you can save your bank account number to speed dial memory. When you call
your bank's telephone teller service and are prompted to enter your account number, simply
press the memory key and the speed dial number where you stored your account nu mber.
Erasing a Stored Number from Memory
1) With the phone in standby mode, press the memory key twice.
2) Press the number of the speed dial entry. A tone indicates that the stored number is
erased from memory.
Changing the Digital Security Code
The digital security code is an identification code used to connect the han dset and the base
unit. Normally, setting the code is not necessary.
The first time you charge your handset, the security code is automaticall y set. In the rare
situation that you suspect another cordless telephone is using the same securit y code, you
can change the code.
1) Remove the handset from the base unit. Press and hold the find hs ke y on the base.
2) While holding the find hs key, place the handset in the base unit. L eave the handset in t he
base for more than three seconds. A new random security code is set.
NOTE: If the handset battery pack is completely discharged or the battery pack is removed,
the digital security code will be lost. If this happens, a new security code is set
automatically next time the battery pack is charged.
Operational Frequency
Frequency 924.516925 – 926.704 425 MHz
2,405.155942 – 2,411.718441 MHz
up077.fm Page 7 Thursday, December 14, 2006 2:31 PM