Filter
Top Products
21
primary line assignment by manually choosing line for your current
task.
To assign a primary line, open the menu and select
Handset Setup
or
Base Setup
. Select
Primary Line
, then choose the line you want this
station to connect to when it goes off hook:
Line 1
Always connect to line 1, regardless of either line's status.
Line 2
Always connect to line 2, regardless of either line's status.
Auto
(default
setting)
Connect to line 1 except under the following circumstances:
there is an incoming call on line 2
there is a holding call on line 2
the answering system has picked up line 2
line 1 is being used for an active call or for screening a call
If any one of these conditions is true, the station connects to line 2.
-
-
-
-
Conferencing two lines together
When you have active calls on both lines, you can join the two lines
together in a conference call.
Place the first call on hold.
Switch to the other line and start the second call.
Press
MENU
, then select
Conference
.
During a conference call, you can speak with both outside callers
at the same time, and the callers can speak with each other.
To separate the conference call back into two independent calls,
press the soft key for either line. The other line is automatically put
on hold, and you can switch between calls normally.
To disconnect both callers at the same time, just hang up
normally.
To disconnect one caller at a time, select the line you want to
disconnect, then hang up. Press the soft key to return to the other
caller (on hold).
Other stations can also join in the conference call. See Using
Multi-station Features on page 29 for more information.
1.
2.
3.