Filter
Top Products
52
53
Troubleshooting
Changing the Line Mode for Multiple Extensions
Line mode refers to the method that telephones use to signal each other that an extension is in use. Customer
service may recommend changing the line mode if you have any of the following problems:
Your phone keeps ringing after someone answers on an extension phone.
Your answering system doesn’t stop recording when you answer on an extension phone.
Caller ID displays briey and then clears.
If you have multiple bases, select the base that is having problems (see page 15).
Press MENU/SELECT.
Select the Global Setup menu, and then the Set Line Mode submenu.
If Instructed by Customer Service Press [select] appears. Press MENU/SELECT.
Move the cursor to select Type - A, Type - B, or Off.
Press MENU/SELECT. You will hear a conrmation tone.
Traveling Out of Range
When the handset is in standby, the handset will display Searching.
During a call, if you move your handset too far from your base, noise may increase. If you pass the range limit of
the base, the handset will beep, display Handset Out Of Range, and then go to standby. The base will maintain the
connection for thirty seconds after the handset goes out of range. If you move the handset back within range of the
base within thirty seconds, press TALK/FLASH or to pick up the call again.
Note: If it is set to automatically select the available base, the handset will begin searching for another base thirty
seconds after going out of range. (see Selecting the base on page 15).
•
•
•
1.
2.
3.
4.
5.
6.
DECT 2015+1 OM.indb 53 7/7/08 12:31:13 PM