18
This device complies with part 15 of the FCC rules. Operaon is subject to the
following two condions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including interfer-
ence that may cause undesired operaon. Privacy of communicaons may not
be ensured when using this phone.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protecon against
harmful interference in a residenal installaon. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instrucons, may cause harmful interference to radio
communicaons. However, there is no guarantee that interference will
not occur in a parcular installaon. If this equipment does cause harmful
interference to radio or television recepon, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separaon between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This product complies with FCC radiaon exposure limits under the following
condions:
The base must be placed to allow a minimum of 20 cm (8 inches) between the
antenna and all persons during normal operaon.
The base must not be collocated or operated in conjuncon with any other
antenna or transmier.
The handset is designed for body-worn operaon and meets FCC RF exposure
guidelines when used with any belt clip, carrying case, or other accessory sup-
plied with this product. (All necessary accessories are included in the package;
any addional or oponal accessories are not required for compliance with
the guidelines.) Third party accessories (unless approved by the manufacturer)
should be avoided as these might not comply with FCC RF exposure guidelines.
•
•
•
•
•
•
•