Filter
Top Products
43
Troubleshooting
Resetting the Handset
You may need to reset your handset in the following instances:
You lose a handset and purchase a new one.
When you try and register to your existing base, you see REGISTRATION FAILED on the menu display.
You are unable to register any handsets to the base.
You had a base which needed to be exchanged by the manufacturer.
When you register your existing handsets to the base, and the handset IDs do not match. (For example, the
handset registers as Handset #4, but you only have two handsets.)
When you are instructed to by the one of the manufacturer’s call center representatives.
To reset the handset, do the following:
Press and hold
[ ] and [#/ ] for at least 5 seconds until the SYSTEM RESET menu appears.
Select DEREGISTER HS submenu. WHICH HANDSET? appears.
Move the cursor to select the handset ID to be deregistered from the list, and then press
.
DEREGISTER HS appears.
The phone will ask you to conrm the deregistration. Move the cursor to YES, and then press .
You will hear a conrmation tone. the handset will delete its own base information without trying to contact the
base. When the base information is deleted, the handset displays MODELS VARY! CHARGE HANDSET ON
THE BASE FOR REGISTRATION OR REFER TO OWNER’S MANUAL.
If the handset cannot contact the base, it displays UNAVAILABLE. Make sure the handset is in range of the base
and the base is connected to power.
Note: It is also possible to reset the handset back to its original factory settings. All changes including phone
-
book entries and Caller ID information will be erased. For more information on resetting the handset back to
factory settings and when you need to do this, see www.uniden.com or call our Customer Service Hotline (For
contact information, see the back pag
e).
•
•
•
•
•
•
1.
2.
3.