Uniden D1789-12 Telephone User Manual


  Open as PDF
of 28
 
English - 25
Bluetooth problems Possible solutions
The D1789 doesn’t
ring when my
cellular phone does.
x Making sure your cellular phone has Bluetooth turned on.
x Making sure your cellular phone is in range of the base.
x Making sure the station’s ringer is not turned off. (The base doesn’t
ring on cellular calls.)
The D1789 paired
with my phone, but
I can’t hear anything
through the station.
x Adjusting the volume.
x Setting your cellular phone to transfer the audio to a Bluetooth
device. Check your phone’s manual for instructions on Bluetooth
setup and options.
x Erase the Bluetooth pairing and repair the cellular phone to the
base. To erase the Bluetooth pairing, see page 14.
Installing a Line Filter or DSL Filter
AtelephonelinefilterorDSLfilterpreventsservicesthatusethephonelinefromcausing
interferenceonyourphone.Togetalinefilter,contactyourserviceproviderorlookinan
electronicsstore.Plugthefilterintothetelephonewalljackandplugthebaseintothefilter.
Makeatestcalltomakesurethenoiseisgone.
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter & phone cord from
the wall before touching it.
Iftheliquidisonlyontheexteriorhousingofthebaseorhandset,wipeitoffanduseasnormal.
Ifyoucanhearliquidinsidethehousing:
1. Removeallcompartmentcovers,anddisconnectallcablesandcords.
2. Ifliquidisleakingfromanyventorhole,turnthephonesothattheventfacesdown.Ifnot,
placethelargestventfacedown.
3. Letdryforatleast3days.Checkforliquidinsidethephonebeforereplacingcompartment
covers&reconnectingcords.
RESETTING STATIONS
Ifyouhaveproblemswiththebase,unplugittoresetit.Plugitbackinafteratleastaminute.
Ifyouhaveproblemswithacordlesshandsetorwanttoreplaceone,resetit:
1. Press&hold
enD
and
#
atthesametimeuntilyouseethe
System Reset
menu.
2. Ifyoustillhavethebasethehandsetisregisteredto,select
Deregister HS
,thenselectthe
handsetyouwanttoreset.Ifyoudon’thavethatbaseanymore,select
Base Unavailable
.
3. Toconfirm,select
Yes
.Thehandsetdisplays
Handset not registered
.
REGISTERING HANDSETS
If
Handset not registered
displaysonahandset,registerthehandsettoabasebeforeusingit.
1. Onthebase,openthemenuandselect
Register Accy
.
2. Onthehandset,pressandhold
#
untilthehandsetdisplays
Registering
.
3. Waituntilthedisplaysays
Registration Completed
(about30seconds),thenpickupthe
handset;press
HOMe/flasH
.
# If you don’t hear a dial tone or the display says
Registration Failed
, charge the battery
completely, then try again.
 previous next