Uniden D1789-11 Telephone User Manual


  Open as PDF
of 28
 
22 - English
To... From the base From a handset
restart this
message
Wait at least 5 seconds after the message starts playing,
press
PHOnebOOk.
Press
1
(number key).
replay an
earlier
message
Within 2 seconds after a message starts playing,
press
PHOnebOOk.
Press
1
(number key).
skip a
message
Press
ciD
. Press
3
(number key).
delete a
message
While a message is playing, press
Delete
.
While a message is playing,
press
4
(number key).
delete all
messages
With the phone in standby, press
Delete
;
press
Delete
again to confirm.
Not available.
play old
messages
After the system plays all new messages,
press
Play/stOP
again. Press
2
(number key).
stop
playback
Press
Play/stOP
. Press
5
(number key).
SCREENING YOUR CALLS
Youcanusetheansweringsystemforcallscreening.Whilethesystemtakesamessage,youcan
listenonthebasespeaker(ifyouturnon
Call Screen)
orfromahandset.Onlyonehandsetcan
screencallsatatime.Ifanotherhandsettriestoscreencalls,itbeepsandreturnstostandby.
To... From the base From a handset
hear the caller leaving a
message
Listen to the caller over
the speaker.
Press
Message/Mute
.
answer the call
Pick up the corded
handset.
Press
HOMe/flasH
.
mute the call screen without
answering*
Press
Play/stOP
.
Press
enD
or return the
handset to the charger.
# If you mute the call screen, the system continues taking the message; it just stops
playing through the speaker.
USING THE ANSWERING SYSTEM REMOTELY
Youcandialintoyouransweringsystemfromanytouch-tonephone.Beforeyoucanusethis
feature,youmustprogramasecuritycode.
Programming a Security Code
Withthephoneinstandby,openthemenu;select
Answering Setup/Security Code
.Usethe
numberkeypadtoenteratwo-digitsecuritycode(
01
to
99
).Press
select
onthebaseor
Menu/
select
onthecordlesshandsetwhenyou’refinished.
# Remember to make a note of your new security code!
 previous next