Filter
Top Products
18
Installing a Line Filter or DSL
Filter
A telephone line lter or DSL lter
prevents services that use the phone
line from causing interference on your
phone. To get a line lter, contact your
service provider or look in an electron-
ics store.
Plug the lter into the telephone wall
jack and plug the base into the lter.
Make a test call to make sure the noise
is gone.
Liquid Damage
CAUTION: If the base is covered in
liquid, disconnect the adapter &
phone cord from the wall before
touching it.
If the liquid is only on the exterior
housing of the base or handset, wipe it
o and use as normal. If you can hear
liquid inside the housing:
Remove all compartment covers,
and disconnect all cables and cords.
If liquid is leaking from any vent
or hole, turn the phone so that vent
faces down. If not, place the largest
vent face down.
Let dry for at least 3 days. Check
for liquid inside the phone before
replacing compartment covers &
reconnecting cords.
Resetting Handsets
If you have trouble with a handset or
if you want to replace one, clear the
registration information from the base
and the handset:
Press & hold
End
and
#
at the same
time until you see the
System Reset
menu.
If you still have the base the handset
is registered to, select
Deregister HS
,
then select the handset you want
to reset. If you don’t have that base
anymore, select
Base Unavailable
.
1.
2.
3.
1.
2.
To conrm, select
Yes
. e handset
displays
Handset not registered
.
Registering Handsets
If you see a “not registered” message on
a handset, you must register it to a base
before using it.
Place the handset in the base;
the display should say
Handset
Registering
.
Wait until the display says
Registration Complete
(about 30
seconds), then pick up the handset
and press
Talk/flash
.
If you don’t hear a dial tone or the
display says
Registration Failed
,
charge the battery completely, then
try again.
Adapter and Battery
Information
AC adapter
Part number PS-0035
Input voltage 120V AC, 60 Hz
Output voltage 8V AC @ 300mA
Use only the supplied AC adapters.
Use the proper adapter for the base &
any chargers.
Do not place the unit in direct sunlight
or subject it to high temperatures.
Battery pack (with normal use)
Part number BT-1021
Capacity 300mAh, 2.4V DC
Talk time about 7 hours
Standby time about 7 days
Battery life about 1 year
Replace the battery when the talk or
standby time becomes noticeably re-
duced. For replacements, call the Parts
Department (see the front cover).
When the battery gets low, the handset
beeps and shows a low battery alert; put
the handset in the cradle for recharg-
ing.
3.
1.
2.
3.