Filter
Top Products
Australian Customers:
Setting the LDS code is not
required.
SETUP
4
NOTE
1.While holding down the del button, press the review dn button once.
2.Use review up or dn buttontoselectthecorrectnumber - HH : MM MM / DD
3.Press call back buttontoconfirmandmovetothenextdigit.
4.Press del buttonto store and exit.
Setting Time and Date
With handset in cradle follow these steps:
NOTE
If you have subscribed to the
Caller ID service, the Time
and Date will automatically
be set when you receive a
call.
NOTE
Match the + / - symbols in
the battery compartment
with each battery.
Battery Installation
Connecting Line Cords
The Caller ID phone requires four 1.5V AAA size batteries for the LCD
display to operate.
1. Remove the screw and open the battery compartment under the base.
2.Insertfour1.5VAAAsizebatteries.
3. Position the batteries in the compartment and replace the
batterycompartmentcover.
Plug one end of the supplied modular cord into the telephone line wall jack. Then
plugtheotherendinto the telephonelinejack located under the base.
Digit Insert Caller ID (LDS Code)
To correctly display and dial Call ID numbers, you may need to insert a digit at the
beginning of your telephone number. (eg: in New Zealand, Telecom requires a ‘0’ to be
inserted.)
New Zealand:
If you subscribe to Telecom New Zealand, this code has already been set for you to ‘0’.
If you subscribe to another telephone company, please set the LDS code as blank ‘ ’.
If this phone is used with a business PABX - consult the PABX manufacturer for the
correct setting.
Australia:
For private household telephone lines, it is not necessary to set this code.
If this phone is used with a business PABX - consult the PABX manufacturer for the
correct setting.
8:06 2/27
SET TIME
(hours : minutes) (month/day)
1. While holding down the del button, press the review up button once.
2. Press review up or dn to select the correct number to be inserted, press
call back to set the next digit, then press del to store and exit.
8:06 2/27
--
SET LDS CODE