Filter
Top Products
TL-WA730RE 150Mbps Wireless Range Extender User Guide
wireless network security, the default SSID is set to be TP-LINK_XXXXXX (XXXXXX
indicates the last unique six numbers of each Router’s MAC address). This value is
case-sensitive. For example, TEST is NOT the same as test.
¾ Region - Specifies the region where the wireless function of the AP can be used. Select your
region from the drop-down list. If your country or region is not listed, please contact your local
government agency for assistance.
) Note:
Restricted by local law regulations, version for North America does not have region selection
option.
¾ Channel - This field determines which operating frequency will be used. The default channel
is set to Auto, so the AP will choose the best channel automatically. It is not necessary to
change the wireless channel unless you notice interference problems with another nearby
access point.
¾ Mode - This field determines the wireless mode which the AP works on.
These settings are only for basic wireless parameters, for advanced settings, please refer to
Section 4.5: "Wireless."
4. Click the Next button. You will then see the Finish page.
Because there are something changed on the Wireless page, you will see the Finish page as
shown in Figure 3-14. Click the Reboot button to make your wireless configuration to take
effect and finish the Quick Setup.
Figure 3-14 Quick Setup – Finish
If you don’t make any changes on the Wireless page, you will see the Finish page as shown
in Figure 3-15. Click the Finish button to finish the Quick Setup.
Figure 3-15 Quick Setup - Finish
16