Filter
Top Products
Topcom Butler M1250/Twin/Triple/Quattro 10
Topcom Butler M1250/Twin/Triple/Quattro
ENGLISH
7.3 Calling a number from the call list
Scroll through the call list until the desired number is shown on the display ÆPress the off-
hook button . The number will be dialled automatically.
7.4 Erasing a number from the call list
Scroll through the call list until the desired number is shown on the display ÆPress the menu
button and select ‘Delete’ ÆPress OK after the confirmation request to confirm.
7.5 Erasing all numbers from the call list
You can only erase all numbers from the call list if all are read.
Press the menu button and select ‘Delete All’ ÆPress OK after the confirmation
request to confirm.
7.6 Store a number from the call log into the phonebook memory
Scroll through the call list until the desired number is shown on the display ÆPress the menu
button and select ‘Save’ ÆEdit the name if nessesary and press OK ÆEdit the
number is nessesary and press OK.
8 Register to a Topcom Butler M1250 base
You can subscribe 4 handsets to one base unit. By default, each handset is subscribed as
handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if:
• The handset subscription has been removed from the base unit (e.g. for reinitialisation)
• If you want to subscribe a different handset to this base unit.
The below procedure is only applicable to a Topcom Butler M1250 handset and base unit!!
Keep the paging key on the base unit pressed for 4 seconds. During one minute the base
unit is in register mode and you must do the following to subscribe the handset:
Press menu button ÆUse the button to scroll to ‘System’ and press
ÆSelect ‘Register’ ÆEnter the base PIN code (default=’0000’) and press . Enter the
number of the base unit you would like to subscribe the handset to (1-4) ÆThe unit will start
searching for the base and when found it will register ÆIf the PIN is wrong, the handset will
restart the searching for the base ÆWhen the handset is registered, it will show the handset
name and at the right the handset number.
8.1 Selecting a base unit
You can switch your handset between different registered base units if you have registered
a handset to more then one base. You can manually select the base unit or automatically let
the handset choose the nearest base.
Press menu button ÆUse the button to scroll to ‘System’ and press
ÆSelect ‘Select base ÆSelect ‘Auto’ or the base number (1-4) by the up/down / keys
and press .