Filter
Top Products
M
12
Domo
12.1. THE TOPCOM DOMO IS SWITCHED ON
• Dial the phone number (from any address) to which your TOPCOM DOMO
is connected.
• You will hear a message followed by a beep. The length of this beep
depends on the number of recorded messages.
• Before you proceed, you can leave a short message which will remind you
later that you have already listened to the messages (this message may
not take more than 1 minute).
In either case, whether you have left a message or not
• After the beep or after that you have left a message, press your 3-digits
code on the keypad (dtmf/tone).
• While rewinding the tape, you will hear a series of short beeps (with a
pause of 3 seconds between each series of beeps).
• If you do not hear this beep, press your 3-digits code again.
• From now on all messages will be played back. You will hear a short beep
between each message.
• When you have listened to all recorded messages, your TOPCOM DOMO
will produce a series of short beeps, indicating that you have heard all the
messages.
• AFTER THESE BEEPS YOU CAN:
1. Save the recorded messages
Put down the receiver after or during the playback of the recorded
messages.
or
2. Erase the recorded messages
Press your remote code and put down the receiver after two short
beeps.
Domo
M
11
11.5 FAST FORWARD DURING THE PLAYBACK OF THE
RECORDED MESSAGES
• Press and hold down the key (memo/fast forward) (7).
• When you have reached the message concerned, release the key
(memo/fast forward) (7) and the playback will resume.
Remark:
If you press and hold down the key (memo/fast forward) (7) until the
end of the tape, your TOPCOM DOMO will automatically rewind and stop. To
listen to the recorded messages again, release the key (play/rewind)
(6).
11.6 MEMO RECORDING
Press the key (memo/fast forward) (7) and start speaking. After your
message, press the key (memo/fast forward) (7) to stop recording.
Your memo will be recorded just like an incoming message and will playback
as the other messages.
12. THE REMOTE CONTROL
Your TOPCOM DOMO can be used from a distance through any dtmf (beep)
telephone. The decoder can be received in option.
At the back of your device there is a code existing out of three digits (look at
the sticker). You need this code in order to use your remote control.