Filter
Top Products
M
10
Domo
11.1. SAVE MESSAGES
• After listening to the recorded messages, push the key
(play/rewind) (6). Press and hold down the key until the led (4)
switches off.
• Release the key (play/rewind) (6). The led (4) will flash again. The
messages are being saved. The new, incoming messages will be recorded
after the ones already saved.
11.2. ERASE MESSAGES.
If you press no key after playing the messages, the already recorded
messages will automatically be erased with the recording of new incoming
messages.
11.3. PAUSE DURING THE PLAYBACK OF THE RECORDED
MESSAGES
• Turn the ON-OFF/VOLUME knob (8) in the off- position, the playback of
the recorded messages will stop.
• Turn the ON-OFF/VOLUME knob (8) in the on-position to continue the
playback of the recorded messages.
11.4. REWIND DURING THE PLAYBACK OF THE RECORDED
MESSAGES
• Press and hold down the key (play/rewind) (6) until the tape has
been completely rewinded.
• When you, release the key (play/rewind) (6), you resume playback.
Domo
M
9
8. POWER FAILURE INDICATION
If there has been a power failure and some messages have been recorded,
the led (4) will flash constantly.
Play the message by pushing the key (play/rewind) (6). The device
will automatically reset itself to the standby position.
9. VOX CONTROL
Your TOPCOM DOMO will automatically stop recording the incoming message
if there has been no voice for more than 7 seconds.
10. TAPE FULL INDICATION
If your tape is full, an incoming message will only be answered after 20 rings.
The caller will not be able to leave a message. You have to listen to all the
calls before you are able to record messages again.
11. PLAYBACK OF RECORDED MESSAGES
• Press and release the key (play/rewind) (6).
• All recorded messages will be reproduced. At the end of the tape you will
hear a beep. The cassette will automatically rewind.