Filter
Top Products
3.3 Registering to a Topcom Butler 565
• Set the base set in registration mode by pressing and holding the paging key until you hear the
registration tone. Now you have 30 seconds to follow the standard registration procedure.
• The Butler 565 default PIN code is ‘0000’.
Note: This base set does not support the unanswered call list for missed calls.
3.4 Registering to a Topcom Butler 575
• Set the base set in registration mode by pressing and holding the paging key for 20 seconds.
Now you hear a beep tone and you can follow the standard registration instructions.
• The Butler 575 default PIN code is ‘1590’.
3.5 Registering to a Detewe Eurix 240
• Set the base set in registration mode by interrupting the power supply for 20 seconds. From
now on, you can follow the standard registration procedure.
• The default PIN code of the Eurix 240 are the last 4 digits of the serial number.
Note: This base set does not support the unanswered call list for missed calls.
3.6 Registering to a Tiptel Dectline C
• Set the base set in registration mode by pressing the paging key for 10 seconds. Now the base
set LED starts flashing and you have 1 minute to follow the standard registration procedure.
• The Tiptel Dectline C default pin code is ‘0000’.
Note: No number display function on incoming calls on the BUTLER 1800T when re g i s t e red to Tiptel and no unanswere d
call list function
3.7 Registering to a Philips Xalio
• Set the base set in registering mode by pressing the paging key for 10 seconds. Now you hear a
beep tone and you can follow the standard registering instructions.
• The Philips Xalio default pin code is ‘1590’.
Note: This base set does not support the unanswered call list for missed calls.
3.8 Registering to an Ascom Avena
• Set the base set in registration mode by pressing the following keys on your Ascom handset:
“P P 903 (new handset number) (PIN code) P”
Now the base set LED starts flashing and you have 1 minute to follow the standard registration
procedure.
• The Ascom Avena default pin code is ‘0000’.
Note: This base set does not support the unanswered call list for missed calls.
3.9 Registering to a Siemens Gigaset
• Set the base set in registration mode by pressing the paging key for 10 seconds. Now you hear a
beep tone and you have 1 minute to follow the standard registration procedure.
• The Siemens Gigaset default code is ‘0000’.
Note: No number display function on incoming calls on the BUTLER 1800T when registered to Siemens Gigaset and no
unanswered call list function.
6
Butler 1800T