Filter
Top Products
Topcom Butler 3100 7
ENGLISH
Put the handset on the base unit. The red Charge LED will burn.
Charge the handset for a period of 24 hours before using the handset for the first time. To extend the battery life time,
decharge the batteries completely from time to time. As soon as the handset emits a warning tone or when the battery
icon is empty, you have to put it back on the base unit.
4. BATTERY EMPTY INDICATION
When the battery is empty, the handset no longer carries out operations. When a battery is completely empty and you
have put the handset on the base unit for a short period of time, the Battery symbol will appear to be fully charged but
this is actually not the case. The battery capacity will decrease rapidly. We advise you to put the handset on the base
unit for the entire night so that it can be recharged thoroughly.
• Full battery
•Empty battery
When you are in the middle of a conversation and the battery is almost empty, the handset will emit a warning signal.
Place the handset on the base unit to charge.
5. OPERATION TELEPHONE
5.1 OUTGOING CALLS
5.1.1 Making a phone call
• Press the Line button . You will hear the dial tone.
• Enter the desired telephone number.
• Press the Line button when you want to terminate the call.
5.1.2 Call setup with dial preparation
• Enter the desired telephone number. An incorrect number can be corrected by means of the Mute button
C
/.
When you haven’t pressed a button for 30 seconds, the number you’ve already entered will disappear and the
handset returns to standby mode.
• Press the Line button . The number will be dialled automatically.
• Press the Line button when you want to terminate the call.
5.2 INCOMING CALLS
•When a call comes in, the handset will start to ring. The LED on the base will blink.
• Press the Line button to answer the incoming call.
5.3 LAST NUMBER REDIAL
• Press the Line button .
• Press the Redial button . The last number (with max. 20 digits) will be dialled automatically.
• Press the Line button when you want to terminate the call.
5.4 PROGRAMMING MEMORY NUMBERS
You can program 10 indirect numbers (of max. 20 digits) in the phone’s memory.
• Enter the telephone number you wish to save on this memory location.
• Press and hold the Memory button until the -icon appears on the display. Enter the memory location (0-9)
where you want to store the number.
• You will hear a confirmation tone and the -icon will turn off.
Remarks :
If you wish to insert a pause, press and hold the Redial/Pause button /P on the location where you want a
pause
HL_B3100_basicsdef_GB.fm Page 7 Monday, May 12, 2003 12:16 PM