Filter
Top Products
70 Topcom Butler 2950
Topcom Butler 2950
The underlined procedure is only applicable to a Topcom Butler 28xx, 29xx handset and base unit!!
Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator
on the base unit begins to blink rapidly. The Line/Charge indicator will blink rapidly
for one minute. During this minute, the base unit is in register mode and you must do the
following to subscribe the handset:
• Press and hold the and key for 3 sec.
•The following will appear on the display:
• Enter the number of the base unit you would like to subscribe the handset to (1-4)
•The unit will start searching for the base and when found it will ask to enter the pin code (4 digits):
• Enter the base pin code (0000). If the pin is wrong, the handset will restart the searching for the base.
•When the handset is registered, it will show ‘HS’ followed by the handset number.
7.2 SUBSCRIBING A TOPCOM BUTLER 300 DECT GAP HEADSET
Press the Paging key on the base unit for 10 seconds until the Line/charge indicator on the base unit starts to blink
quickly. The line/charge indicator will blink quickly for one minute. During this minute, the base unit is in subscribing
mode and you must do the following to subscribe the headset:
-Turn ON the headset by pressing the ON/OFF button until you hear two beep tones. At the same time the red and
green LED will lit ones.
- Remove the rubber cover of the power socket so that the hole of the power socket is free. Pull out the rubber cover
from the headset so that the registration key hole is free also.
- Press the headset registration key. The red LED will flash rapidly.
- If after a few seconds the green LED flashes slowly, the registration is successful.
- If the red LED flashes slowly, the registration is failed. Repeat above procedure.
7.3 REMOVING A HANDSET
You can remove a handset from a base to allow another handset to be registered:
• Press and hold the mute and redial key for 3 sec.
• Enter the pin code (0000). If the pin is wrong, the handset will go back to standby.
• Enter the handset number (1-5) you want to remove
PIN
PIN 1234 H5-