Filter
Top Products
68 Topcom Butler 2950
Topcom Butler 2950
5.8 PAGING
When you press the Paging button on the base unit, the handset emits a ringing signal for 20 seconds. This signal
helps you find a lost handset. Press any key to stop the ringing on a handset.
5.9 OUT OF RANGE WARNING
When the handset is out of the working range of the base unit during a conversation, the unit will emit a warning signal
to warn the user that he has to move closer towards the base unit.
5.10 FLASH BUTTON (R)
When you press the R button, also called flash or recall, the unit generates a line interruption (of 100 ms or 250 ms). It
gives you the possibility to use the special services of your telephone provider and/or to transfer calls when you have
a telephone exchange.
5.10.1 Setting the Flash time
• Press and hold the redial button for 3 sec.
•The display will show: ‘S’ for 100ms or ‘L’ for 250ms
•The flash time setting will disappear after 2 sec. from the display
5.11 SETTING THE RING VOLUME AND MELODY
5.11.1 Handset melody
• Press and hold the melody button until the current melody is heard.
• Select the desired melody (1-9) by means of the scroll keys or by entering a number (1 - 9).
• Press again to confirm the setting
5.11.2 Handset ring v
olume
• Press the volume button in standby
•The handset will ring in the current volume
• Press 1-5 or use the scroll keys to select the desired volume
• Press ’0’ to turn the volume OFF
5.11.3 Setting the ring v
olume level of the base
You can change the ring volume and melody of the Butler 2950 base.
•When base is ringing
• Press volume key on base to increase or decrease ring volume
Remark:
- You can turn the ringer volume of each individual handset ON or OFF by simply press and hold the key
in standby.
5.12 KEY LOCK
When the keypad is locked, pressing any key will have no effect during standby (except holding the key).
• Press and hold the key
• appears on the display and the keypad is locked
• Press and hold the key again to un-lock the keypad
When there is an incoming call, you can still answer the call by pressing the Line button . During the call, the keypad
functions as normal. When the call is ended, the keypad will be locked again
5.13 SETTING THE DIALLING MODE
There are two types of dialling mode:
DTMF/Tone dialling (the most common) (default)
Pulse dialling (for older installations)
To change the mode of dialling:
• Press and hold the flash R button to toggle between dialling modes:
‘P’ will appear when set to pulse or ‘T’ when set to tone (DTMF) dialling
•After 5 sec. the unit returns to standby