Filter
Top Products
Butler 2000 C
Handset
• P r ess the Function button
until “H-REGISTER” is
shown on the display.
• Press the OK button.
• On the display “SEARCH
BS 1” is shown.
• Press the Function button.
• The base number changes
from 1 to 4.
• As soon as the handset has found the correct
base number, press the OK button.
• When the handset is
looking for the base
unit, the RFPI Code is
displayed.
• Press the OK button.
• When “PIN:“ is
displayed, enter the PIN
code of the base unit
(PIN code = depends on the base station).
• After entering the 4 digit PIN code, press the OK
button.
• The unit returns to the
“H-REGISTER” menu.
5 TELEPHONE OPERATION
ATTENTION
How to use the handset depends on the base to
which the handset has been re g i s t e r ed. Some of the
below mentioned functions will not be available
because the are not supported by the DECT base,
especially the function ‘identification caller’. The fol-
lowing functions are for the handset that has been
re g i s t e red to the Topcom Butler 2000 base.
5.1 Answering Incoming Calls
The user can accept an incoming internal or extern a l
call by pressing the Hookswitch button. The INT
( i n t e rnal incoming call) or the EXT (external incoming
call) symbol blinks on the display. As soon as the call
is accepted, the symbol stabilizes on the display. In
the event of internal calls, only the called handset will
ring and show a flashing INT symbol. The number of
the calling handset is displayed on the left hand side
of the display. In the case of an external call, all fre e
handsets will ring and all handsets (free or busy) will
show a flashing EXT symbol.
5.2 Outgoing Calls
5.2.1 External outgoing calls
• When you want to make a phone call, press the
Hookswitch button .
• The symbol is displayed.
• You will hear the dial tone and “EXT“ appears
on the display.
• Enter the telephone number. After 10 sec. the call
44
44
44
44
44
44
44
44
44
PIN:
* * * *
H - - R E G I S T E R
00004-00 1AB
H - - R E G I S T E R
SEARCH BS 1
B2000C 10/9/01 11:32 am Page 44