Symbol Technologies CDM-8910WW Telephone User Manual


 
C
H
4
55
C
H
4
54
MEDIA GALLERY
54
SETTINGS
1
Press [MENU] .
PHOTO
1
Press [MENU] .
TONES
2
Scroll through the captured pictures to display the
picture you want to send, then press [SEND].
3
The New Photo Msg screen will appear. Enter the
information in all the necessary fields. See "New
Photo Msg" on page 102.
4
2
Scroll to the saved voice memo or downloaded
ringtone you want to send then press [SEND].
3
The New Photo Msg screen will appear. Enter the
information in all the necessary fields. See "New
Photo Msg" on page 102.
4
Press [MENU] to select 1.Erase, 2.Erase All, 3.Change Title.
Sets Ringer Type, Volume, Alert, Roam Ringer, Tone Length and Etiquette.
This menu shows the list of photos that have been taken with the camera.
This menu shows the list of downloaded ringtones and saved voice memos.
Sending tones or voice memos is done through the New Photo Msg screen.
To select a ringer type for incoming calls:
To select a ringer type for receiving messages:
To select a ringer type for receiving voice mail:
Customizes your phone and optimizes performance through a variety
of settings.
SOUNDS
RINGER TYPE
1
Press [MENU] .
2
Select your desired ringer type.
3
Select one of the available ring types.
To confirm, press [SELECT].
RINGER
2
Press the Navigation Key up or down to select
“Tone 1, 2, 3, 4, 5”.
3
To confirm, press [SELECT].
2
Press the Navigation Key up or down to select
“Tone 1, 2, 3, 4, 5”.
3
To confirm, press [SELECT].
1
Press [MENU] .
MESSAGES
1
Press [MENU] .
VOICE MAIL
Left or Right key : Select “Ring Tones”, “Music Bells” or
“Downloads”.
Up or Down key : Select “Ringer”.
Downloads : Downloaded ringer types and familiar music.
4.1 To send the photo message, press [MENU]
then select “Send”, then press [OK].
4.2 To save the photo message, press [MENU]
then select “Save to Outbox”, then
press [OK].
4.1 To send the photo message, press [MENU]
then select “Send”, then press [OK].
4.2 To save the photo message, press [MENU]
then select “Save to Outbox”, then
press [OK].